How to install earth copper tube electrode.

In previous post, we learn how earth/grounding system works in single phase and three phase at home and industry. In order your house must to be safe from any electrical fault, you need a good earthing system to provide protection to consumer. So dummies!!! take all tools and electrical equipment,because we going to learn how to install earth copper tube electrode.Time to dig some holes on ground!!!!

You have been saw this picture above shown.This earthing system as the picture above shown is helpful to understand how to install earth electrode copper tube to protect your house from electrical fault. The earth electrode copper tube is at outdoor in the ground. The wire is connect earth bus bar in distribution board and connect outside to the earth copper tube. Sounds easy,but the work to do is hard. So let see how this work done.

First step :

Dig a hole in 6 inches or more to make fit the earth chamber in the ground.

Second step :

Now push the copper tube in the ground. If the ground too hard,pour a little water to make wet and easily to push in. If some huge stone inside hole, remove the stone with showel or move a new place to make new hole.

   
Third Step : 

Now, put the earth chamber in the hole. Make sure the earth chamber don't go deep or high enough.

  
Fourth Step :

Now install earth clamp and tight the earth wire from underground.

  
Fifth Step :  

Secure the earth chamber with put back the cover.

 
Final Step 

Taaaa!!! daaaa!!! finally, you done install earth electrode copper tube in the ground.

WELL YOU LEARN HOW TO INSTALL EARTH ELECTRODE IN THE GROUND.,BUT THERE'S ONE MORE THING TO LEARN. THAT'S THE EARTH RESISTANCE TESTING AND SOME PROBLEMS WE FACE TO MAKE THE EARTH RESISTANCE STABLE. TILL THEN, READ MY OTHER POST THAT MIGHT HELP YOU AND STAY ELECTRIFYING