Tuesday, 6 September 2016

How to make end cap for trunking

We previously learn about how to make tee junction,90 and 45 angle. The last final one for this trunking is making end box. To do end box fro trunking is easy and simple to master the skill to do. You can make end box to any size of trunking anyway as the 90 or 45 and tee junction do also. So let make end box for trunking.
   
Tools needed :

Metal cutter
Ruler or Measuring tape
Pencil (for draw lines on trunking)




WARNING : 
BE CAREFUL WHEN YOU CUT TRUNKING,THIS MAY CAUSE INJURIES FROM SHARP EDGES BY CUTTING THE TRUNKING. WEAR GLOVES TO AVOID INJURIES.

1) prepare tools and trunking to get started.

2) Now measure the end of trunking in 50mm.

3) Make a line at left,right and middle of trunking after measure in 50MM.

4) Cut the sharp edges by guided red circle and make it short,because it can easily move in the trunking.

5) Now slot the end part inside the trunking
   
6) Finally you done a perfect end cap for trunking 

YOU CAN MAKE THIS END BOX FOR TRUNKING IN ANY ANGLES. THIS END BOX IS TO END THE WIRING TO ONE PLACE OR TO MAKE ADDITIONAL END CIRCUIT LIKE SOCKETS AND LIGHTS. 

No comments:

Post a Comment